Thingiverse
Rear Assembly OpenRC Truggy for HSP 188015 and diff HSP 02024
by NiKO2On
84
Downloads
67
Likes
1
Makes
ENGLISH
This configuration provides a large stroke for 12 cm wheels.
To print the levers it is desirable to use Brim 5mm. The rest of the details are printed without a skirt and without support by a layer 0.2-0.25 mm> = 25% filling.
The rear hub uses two different-sized ball bearings. This provides greater node reliability, less backlash. A large ball bearing closes the pin on the cup.
- Screws M2.5x10mm
- Bearings
https://egorniko.ru/r/Y (5x10x4 mm)
https://egorniko.ru/r/Z (10x15x4
This configuration provides a large stroke for 12 cm wheels.
To print the levers it is desirable to use Brim 5mm. The rest of the details are printed without a skirt and without support by a layer 0.2-0.25 mm> = 25% filling.
The rear hub uses two different-sized ball bearings. This provides greater node reliability, less backlash. A large ball bearing closes the pin on the cup.
- Screws M2.5x10mm
- Bearings
https://egorniko.ru/r/Y (5x10x4 mm)
https://egorniko.ru/r/Z (10x15x4
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in