Thingiverse
Snapmaker Pi Camera Mount & Holder
by kelvin8r
378
Downloads
163
Likes
4
Makes
This is an attachment for mounting a Raspberry Pi Camera to the Snapmaker if you're running OctoPrint.
The arm swings from the front to 90 degrees to the right side of the printer bed. There are notches in the base in 15 degree increments.
The Pi Camera case and bracket are remixed from this mount https://www.thingiverse.com/thing:2265949.
Everything is snap fit, except for mounting the base to the printer and mounting the arm to the base. Details in **Print Settings** below.
The arm swings from the front to 90 degrees to the right side of the printer bed. There are notches in the base in 15 degree increments.
The Pi Camera case and bracket are remixed from this mount https://www.thingiverse.com/thing:2265949.
Everything is snap fit, except for mounting the base to the printer and mounting the arm to the base. Details in **Print Settings** below.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in