Thingiverse
ANET A8 Small Filament Holder
by Bedingjd
4
Downloads
0
Likes
0
Makes
The project is a filament holder that attaches to the existing ANET A8 filament holder.
This was inspired by filamentry's excellent design, TUSH The Ultimate Spool Holder, at https://www.thingiverse.com/thing:2047554, where the filament spool rests on 608 bearings. However the print time for the TUSH was a little longer than I wanted (I'm impatient). Therefore, taking the idea of a bearing filament holder, this design slims it down to just the essentials. It assumes you already have the fila
This was inspired by filamentry's excellent design, TUSH The Ultimate Spool Holder, at https://www.thingiverse.com/thing:2047554, where the filament spool rests on 608 bearings. However the print time for the TUSH was a little longer than I wanted (I'm impatient). Therefore, taking the idea of a bearing filament holder, this design slims it down to just the essentials. It assumes you already have the fila
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in