Thingiverse
CR-10 X Stop NON metric adjust
by WADUHEKDIS
10
Downloads
4
Likes
0
Makes
remix to imperial (non metric) hardware I make for friend in the US
require
2x #6-32 nuts
1x #6-32 1 1/2" mashine screw
see thingiverse I remix from for insrucion on assembles, be sure to thread into the plastics the screws from above, and the screws from factory z stop bracket and sensor before you are putting it on the printer. My friend print with .2mm layer with support, work good for him, he said holes are tight but they should be for making the screws fitting good.
https://www
require
2x #6-32 nuts
1x #6-32 1 1/2" mashine screw
see thingiverse I remix from for insrucion on assembles, be sure to thread into the plastics the screws from above, and the screws from factory z stop bracket and sensor before you are putting it on the printer. My friend print with .2mm layer with support, work good for him, he said holes are tight but they should be for making the screws fitting good.
https://www
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in