FlyWheel for Improved Needle Cutter Grub Screw Mount

This is a remix of jhitesma neede cutter flywheel.

I purchased the Emax CF2822 Motor that goes with the remixed mount of jhitesma original, that I could not find a motor for. Not sure why the mount was remixed, perhaps it was to not have to cut the shaft shorter.

Mount I printed for the Emax Motor https://www.thingiverse.com/thing:2545595

This flywheel uses 2 4mm grub screws in the back to keep it balanced. I still managed to put 2 3mm screws in the back to counter balance the bearing.