Thingiverse
Bowden Extruder (manually loosened) for Micromake C1 and other
by Gipsz
16
Downloads
13
Likes
0
Makes
I modified "Super Bernis simple MK8 bowden extruder" Lever, that the printer's conversion (linear rails) becomes redundant, the bearings in the V -slot roller are usable.
The hole was then increased to 5mm and the bearing support was reduced to 4mm.
I use for Micromake C1, MK8 direct drive extruder.
Much better than the original, because it can be relaxed with one motion (no need to twist) and constant spring force results in proper movement.
The tension spring is exactly the same as the
The hole was then increased to 5mm and the bearing support was reduced to 4mm.
I use for Micromake C1, MK8 direct drive extruder.
Much better than the original, because it can be relaxed with one motion (no need to twist) and constant spring force results in proper movement.
The tension spring is exactly the same as the
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in