Thingiverse
SSR Enclosure with wire retention loops Solid State Relay
by Havoc340
61
Downloads
21
Likes
0
Makes
This is a safety enclosure for a Solid State Relay. It mounts centered on a 2040, but absolutely could be mounted on a 2020 extrusion.
Having an uncovered relay is a potential hazard, especially if being used for AC mains.
The venting is designed for a vertical mounting, however if you are not overloading the relay you shouldn't have issues mounting this in any orientation.
My print was printed with a 1mm nozzle, .45 layer height. your print may come out nicer.
Use M4x16 screws t
Having an uncovered relay is a potential hazard, especially if being used for AC mains.
The venting is designed for a vertical mounting, however if you are not overloading the relay you shouldn't have issues mounting this in any orientation.
My print was printed with a 1mm nozzle, .45 layer height. your print may come out nicer.
Use M4x16 screws t
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in