Thingiverse
Lab holder
by mhfalken
38
Downloads
37
Likes
0
Makes
Here is my lab holder. The holding pads can be interchanged so different versions can be used. (Only one type at the moment.)
Pads: PETG 100um
Arms: PLA 150um, fill 30%
Screw/nut: PLA 100um, fill 40%
The pads are printed in PETG because else the holder tabs will break off.
The pad holes in the arms are designed to be 5mm, but most printers will make them a bit smaller. I hand-drill mine to 5mm for a better fit for the pads.
The spring is homemade from a 0.6mm piano wire.
The idea is
Pads: PETG 100um
Arms: PLA 150um, fill 30%
Screw/nut: PLA 100um, fill 40%
The pads are printed in PETG because else the holder tabs will break off.
The pad holes in the arms are designed to be 5mm, but most printers will make them a bit smaller. I hand-drill mine to 5mm for a better fit for the pads.
The spring is homemade from a 0.6mm piano wire.
The idea is
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in