Thingiverse
Teapot Racing - Seesaw Bridge
by YourLaser
22
Downloads
14
Likes
0
Makes
One of a series of course obstacles for Steampunk Teapot Racing
Teapot Racing?
http://chepstowsteampunk.org/teapot-racing/
This is a seesaw bridge. Drive the Teapot Racer up it and it will tilt over, allowing the Racer to continue on its way.
It's all cut from 3mm material. Ideally the main road surface would be hardboard (Masonite) which laser cuts really badly, but has a rough surface for extra grip. The parts are also quite large - 500 mm long. It's recommended to stick some folde
Teapot Racing?
http://chepstowsteampunk.org/teapot-racing/
This is a seesaw bridge. Drive the Teapot Racer up it and it will tilt over, allowing the Racer to continue on its way.
It's all cut from 3mm material. Ideally the main road surface would be hardboard (Masonite) which laser cuts really badly, but has a rough surface for extra grip. The parts are also quite large - 500 mm long. It's recommended to stick some folde
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in