Thingiverse
Smart Effector 40mm Noctua fan duct
by RGN01
53
Downloads
47
Likes
1
Makes
I wanted to fit a Noctua 40mm fan to my Smart Effectors (one with an e3V6 and one with a Volcano) so came up with this.
One of my design objectives was to mechanically isolate the fan duct from the heatsink and the Z-probe capability so this mount fits onto the ball studs and only touches the PCB at these points.
There are four versions:
- one for no accessories (both ball stud mounts are the same height)
- one that allows various accessories to be added (through having one 'foot' thinne
One of my design objectives was to mechanically isolate the fan duct from the heatsink and the Z-probe capability so this mount fits onto the ball studs and only touches the PCB at these points.
There are four versions:
- one for no accessories (both ball stud mounts are the same height)
- one that allows various accessories to be added (through having one 'foot' thinne
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in