Eachine Pro58 module cover for Flysight Falcon FG01 fpv goggles

This is a cover for the Eachine Pro58 diversity module for the Flysight FG01 FPV goggles.

### 20180407 - v4
- Increased the size of the little "tabs" that hold the cover in place so that now it will not get off too easily
- Increased hole size for the antennas, making installation easier
- I printed with PLA at 0.1mm resolution with supports on a Prusa Mk2 and the result is great. Might try with ABS / PETG or even Polycarbonate for fun.
- The 3d model is not perfect, thus when printing at 0.1mm you might see minor defects in the walls, I don't know how to fix this so I think I won't bother.

### 20180331 - v2
- The cover fits perfectly
- The antenna holes are really slightly off but it fits. I might need to move them 0.4mm right and increase the hole diameter by 1mm
- The hole for the wheel button is a bit too small, a little bit hard to use it because the way the module is made makes it very close to the edge of the goggles.

### Print instructions
Print face down (you