Thingiverse
BaoFeng BF-T1 Mini Desk Stand Holder Charging Dock
by W8MCC
29
Downloads
35
Likes
2
Makes
Print this with the uprights vertical, add support under the base only and then sand smooth or break away if it prints clean.
The model loads into Cura 180 degrees upside down, I dont know how to fix that, but if you just flip it right side up its ready to print!
The holder supports the factory USB charging cord, it is a press fit and will not move when you insert or remove the radio.
The model loads into Cura 180 degrees upside down, I dont know how to fix that, but if you just flip it right side up its ready to print!
The holder supports the factory USB charging cord, it is a press fit and will not move when you insert or remove the radio.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in