Thingiverse
Creality Ender 2 Sensor Mount 18mm
by Avantus_Dax
18
Downloads
7
Likes
0
Makes
This is a sensor mount for the Ender 2.
The hole has a diameter of 18,5mm for 18mm probes.
The mount was printed in ABS but PLA works as well.
It is designed to be used with an inductive sensor alongside the fan shroud Thing found here: https://www.thingiverse.com/thing:2774822
It could fit other fan shrouds as well but that is not tested yet.
The sensor is not using up any Space and the Endstop can be used without any issues.
An infill percentage of minimum 25% is need due to the part wob
The hole has a diameter of 18,5mm for 18mm probes.
The mount was printed in ABS but PLA works as well.
It is designed to be used with an inductive sensor alongside the fan shroud Thing found here: https://www.thingiverse.com/thing:2774822
It could fit other fan shrouds as well but that is not tested yet.
The sensor is not using up any Space and the Endstop can be used without any issues.
An infill percentage of minimum 25% is need due to the part wob
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in