Thingiverse
Anet A6 Blower duct (fan nozzle)
by Nan_1
13
Downloads
14
Likes
0
Makes
This is a blower duct (fan nozzle) for the Anet A6 3D-printer
The original fan nozzle graduatly slipped down and got stuck on the printed item, or fell off completely.
When I was looking for a better solution, all I could find were proper ones for the Anet A8, not the A6, so I decided to make my own.
This design is made in such a way, that the nozzle makes use of internal guide fanes to directs the fan air in a wide angle towards the nozzle without being obstrusive. The best part is that
The original fan nozzle graduatly slipped down and got stuck on the printed item, or fell off completely.
When I was looking for a better solution, all I could find were proper ones for the Anet A8, not the A6, so I decided to make my own.
This design is made in such a way, that the nozzle makes use of internal guide fanes to directs the fan air in a wide angle towards the nozzle without being obstrusive. The best part is that
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in