Thingiverse
2.5 inch quad H-frame
by deaderbug
5
Downloads
4
Likes
0
Makes
Wanted a small 2.5 inch freestyle true X frame that protected the camera. The motor spacing is 106mm long and wide.
The top and bottom plate are the same. have two arms and two bodies cut out of 2mm carbon fiber. I use 4 - 3mm tall 3mm nuts to attach the arms to the bottom body, then some 20mm standoffs in the corners and 2 25mm standoffs in the mid section of the frame. Mount 20x20 stacks in the middle for the ESC and FC and a 20x20 stack in the back for the RX and VTX.
added backpack for
The top and bottom plate are the same. have two arms and two bodies cut out of 2mm carbon fiber. I use 4 - 3mm tall 3mm nuts to attach the arms to the bottom body, then some 20mm standoffs in the corners and 2 25mm standoffs in the mid section of the frame. Mount 20x20 stacks in the middle for the ESC and FC and a 20x20 stack in the back for the RX and VTX.
added backpack for
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in