Thingiverse
Dynam ME-262 Intakes
by s737500
16
Downloads
20
Likes
0
Makes
I wanted to try make some new scale intakes for the Dynam ME-262.
With my limited 3d skills, I only just managed to make these.
Feel free to modify the files to make them better, but then please share them again :-)
The intakes are printed in PLA at 0.2mm layer height, 0.7mm line width, 215c degrees for high strength, 50c bed temp., and at 25mm/s print speed. 0% infill. 1 perimiter shell, 2 top and 2 bottom layers.
In simplyfy 3D you need to go to the advanced page and select "Allow s
With my limited 3d skills, I only just managed to make these.
Feel free to modify the files to make them better, but then please share them again :-)
The intakes are printed in PLA at 0.2mm layer height, 0.7mm line width, 215c degrees for high strength, 50c bed temp., and at 25mm/s print speed. 0% infill. 1 perimiter shell, 2 top and 2 bottom layers.
In simplyfy 3D you need to go to the advanced page and select "Allow s
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in