Thingiverse
Filament Runout Sensor V2 - for Makerbot/RepRap/Geetech mechanical endstop
by BETLOG
17
Downloads
3
Likes
0
Makes
Filament Runout Sensor - Revisited
Smaller.
No lever on the microswitch; direct button pushing.
Connects to the extruder, so impossible to forget.
- 2018-04-07--12-33-40
I have some poorly wound filament that is intermittently wiggly. This often causes misreading of the runout sensor. I have discontinued using this sensor becasue of this, and will defer to my previous version for now.
ie: if your filament is normal it should work fine. If your filament is highly irregular in diamet
Smaller.
No lever on the microswitch; direct button pushing.
Connects to the extruder, so impossible to forget.
- 2018-04-07--12-33-40
I have some poorly wound filament that is intermittently wiggly. This often causes misreading of the runout sensor. I have discontinued using this sensor becasue of this, and will defer to my previous version for now.
ie: if your filament is normal it should work fine. If your filament is highly irregular in diamet
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in