Thingiverse
SparkMaker screen leveller for LCD Mod
by keyz182
35
Downloads
17
Likes
0
Makes
A spacer for the Sparkmaker to stop the FEP pressing too hard on the LCD after doing the LCD mod.
The "-Split-" STLs are by request for someone with a small print bed.
V2
--
I noticed that my measurements didn't take into account that the glass sits a little lower than the top of the unit, so there was a very thin gap between the screen and FEP. V2 has shrunk the height by 0.15 mm to account for this.
Important note!
============
You still need to put black tape around the screen ot
The "-Split-" STLs are by request for someone with a small print bed.
V2
--
I noticed that my measurements didn't take into account that the glass sits a little lower than the top of the unit, so there was a very thin gap between the screen and FEP. V2 has shrunk the height by 0.15 mm to account for this.
Important note!
============
You still need to put black tape around the screen ot
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in