Thingiverse
LoRa antenna jig
by dedehai
164
Downloads
129
Likes
0
Makes
A 3D printable jig to make your own 868MHz LoRa antenna. The length of the rods/tubes can be measured with the jig and it helps A LOT with the assembly.
There are instructions and measurements available on [my blog](https://bashtelorofscience.wordpress.com/2018/04/03/diy-lora-antenna/).
There are instructions and measurements available on [my blog](https://bashtelorofscience.wordpress.com/2018/04/03/diy-lora-antenna/).
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in