Thingiverse
Wemos D1 OLED aka ESP12F OLED case
by Spiritdude
35
Downloads
19
Likes
0
Makes
Wemos D1 OLED aka ESP12F OLED case, with Reset and Flash button built-in.
Nozzle: 0.4mm
Layer height: 0.2mm (or less)
Note: your printer must be well calibrated X/Y and extrusion flow, if the cover won't fit, file the cover guides or the inside of the bottom case.
Gently remove the print of the cover from the print bed.
Nozzle: 0.4mm
Layer height: 0.2mm (or less)
Note: your printer must be well calibrated X/Y and extrusion flow, if the cover won't fit, file the cover guides or the inside of the bottom case.
Gently remove the print of the cover from the print bed.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in