Thingiverse
Lamp for ESP8266 and LED
by oleost
79
Downloads
51
Likes
0
Makes
Please post your make if you make one.
I included two lamps.
One is just round without any internal "support" material, this is the one I printed but I cut it at layer height 95.5mm in my slicer software to keep the lamp open.
The other one with internal "support" is made so the top of the sphere is 70deg overhang, so it should in theory print without any addiotional support.
The ESP8266 I use is https://www.banggood.com/NodeMcu-Lua-WIFI-Internet-Things-Development-Board-Based-ESP826
I included two lamps.
One is just round without any internal "support" material, this is the one I printed but I cut it at layer height 95.5mm in my slicer software to keep the lamp open.
The other one with internal "support" is made so the top of the sphere is 70deg overhang, so it should in theory print without any addiotional support.
The ESP8266 I use is https://www.banggood.com/NodeMcu-Lua-WIFI-Internet-Things-Development-Board-Based-ESP826
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in