Thingiverse
Wallmount screwdriverrack
by s0h0punk
8
Downloads
5
Likes
1
Makes
A 'universal' wallmount screwdriverrack. Holds 21 screwdrivers.
Print at 100% for your average screwdrivers - 120% or larger for those few really big ones (if your print bed is large enough).
spacing between the holes at 100% is 2.5cm (so handles up to 5cm in diameter fit).
For best results, lay it top down in your slicing software since that's the biggest flat area.
I had some underextrusion at the end (you can see it in the final pictures), because my spool decided to leave the table m
Print at 100% for your average screwdrivers - 120% or larger for those few really big ones (if your print bed is large enough).
spacing between the holes at 100% is 2.5cm (so handles up to 5cm in diameter fit).
For best results, lay it top down in your slicing software since that's the biggest flat area.
I had some underextrusion at the end (you can see it in the final pictures), because my spool decided to leave the table m
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in