Thingiverse

Mount for MOSFET-board inside control box Wanhao Di3

by printingotb

14 Downloads

7 Likes

0 Makes

Download Model

Control box MOSFET mosfet mount Wanhao Duplicator I3 Wanhao I3 Wanhao i3 mods Control box MOSFET mosfet mount Wanhao Duplicator I3 Wanhao I3 Wanhao i3 mods

I didn't find any mosfet-board holder to my liking so I made my own. This holder sits firm with no additional glue. Printed with red PETG in the picture.
Prints with four M3 threaded holes. Using two screws should be enough. 8mm long.
Make sure to cut your mosfet-to-PSU wires long enough for easy control-box reassembly.

Installation guide:
http://thatnerdchannel.blogspot.se/2017/06/mosfet-upgrade-wanhao-duplicator-i3-v21.html

If this helped you, consider posting a "make" or even tip me

Source

Thingiverse

Comments

Makes