Thingiverse
Turbine blower
by nfmeola
6
Downloads
2
Likes
0
Makes
My turbine blower.
After print I found that the cap is to small. make it a little bit bigger in the slicer (about 102%) or fix the model before print.
I tested it with 30000 RPM with a dremel and it didn't break. It made a huge wind.
I'm not fully happy with it, so maybe i'll do better next time.
Have fun.
After print I found that the cap is to small. make it a little bit bigger in the slicer (about 102%) or fix the model before print.
I tested it with 30000 RPM with a dremel and it didn't break. It made a huge wind.
I'm not fully happy with it, so maybe i'll do better next time.
Have fun.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in