Thingiverse
Cantilever bed MGN12 Z axis mounting set.
by plebeiu
38
Downloads
22
Likes
0
Makes
I've learned the mgn/lineal rails set on Z is stiffer and definatelly an improvement over the lineal lmXuu bearings and smooth rods... but since these 2 were not in a single piece there was some rocking on the X axis direction of the xy plane (printing bed)...
Having the both mgn12h joined in the center made the bed very stable... there is virtually no vibrations
This is for original tech2c hypercube (200 mm printing cube)
Having the both mgn12h joined in the center made the bed very stable... there is virtually no vibrations
This is for original tech2c hypercube (200 mm printing cube)
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in