Thingiverse
iZeeWobble - Overcomplicated Z-Wobble Printing Test
10
Downloads
4
Likes
0
Makes
*[Make. Break. Repeat! on Facebook](https://www.facebook.com/makebreakrepeat/): Updates on Tuesdays and Thursdays!*
I've been struggling with extrusion issues on my Genuine Prusa i3 MK2.5 since I upgraded from MK2S to MK2.5. One of the theories to be tested was that there was a Z-wobble issue to address first. In the end it turned out I had a bad stepper motor as well as a bad hot-end. After replacing these parts with new parts sent by the excellent Prusa support everything prints properly no
I've been struggling with extrusion issues on my Genuine Prusa i3 MK2.5 since I upgraded from MK2S to MK2.5. One of the theories to be tested was that there was a Z-wobble issue to address first. In the end it turned out I had a bad stepper motor as well as a bad hot-end. After replacing these parts with new parts sent by the excellent Prusa support everything prints properly no
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in