Thingiverse
Craftsman Saw Knob
by jovial_cynic
35
Downloads
16
Likes
0
Makes
The knobs to adjust the height and angle on my Craftsman table saw broke, so I printed new ones.
The relevant measurements were the shaft diameter, shaft length, and the "key" or notch in the shaft.
Diameter: 10mm
Length: 15mm
Key: 2mm
In Blender, I first made a cylinder and then boolean-cut the key out and extruded it out to 15mm. I then designed the knob itself, and used the first cylinder to boolean-cut it out of the knob.
7/5/2023: V2 has been uploaded; the knob now has a wide
The relevant measurements were the shaft diameter, shaft length, and the "key" or notch in the shaft.
Diameter: 10mm
Length: 15mm
Key: 2mm
In Blender, I first made a cylinder and then boolean-cut the key out and extruded it out to 15mm. I then designed the knob itself, and used the first cylinder to boolean-cut it out of the knob.
7/5/2023: V2 has been uploaded; the knob now has a wide
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in