Thingiverse
Armattan Rooster & chameleon Ti axii mount
by Kab00ese
33
Downloads
34
Likes
0
Makes
no supports needed, allows you to retain stock backplate and standoffs for warranty and strength.
note: rotate model to the flat side down before printing
EDIT:
Added file with smaller tube holes to be used with reddy straws as antenna tubes
4-24-18: added a reddy straw compatible file with a small antenna part so it sticks out a bit and doesn't fall inside
reddy straws are the same straws you get with wd40 or brake cleaner and can be found on ebay in 20 packs for $6! At 7'' each
note: rotate model to the flat side down before printing
EDIT:
Added file with smaller tube holes to be used with reddy straws as antenna tubes
4-24-18: added a reddy straw compatible file with a small antenna part so it sticks out a bit and doesn't fall inside
reddy straws are the same straws you get with wd40 or brake cleaner and can be found on ebay in 20 packs for $6! At 7'' each
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in