Thingiverse
IGUS RJ4P-01-08 Bearing holder for Prusa/ Anet Carriage
by XRT9
34
Downloads
22
Likes
0
Makes
Igus rj4jp-01-08
For Prusa bear Full i3 or any other 8mm linear rail system
3mm bolts and nuts can be used with this set up
Do not over tighten bolts. As with any "plastic" bearing they will deform under extreme pressure. if you are experiencing them being tight loosen up the bolts. Best way is to first test them on the rod before installing onto the printer. Will save you some headaches!
Happy printing!
For Prusa bear Full i3 or any other 8mm linear rail system
3mm bolts and nuts can be used with this set up
Do not over tighten bolts. As with any "plastic" bearing they will deform under extreme pressure. if you are experiencing them being tight loosen up the bolts. Best way is to first test them on the rod before installing onto the printer. Will save you some headaches!
Happy printing!
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in