Thingiverse
Inclined Spool Holder 22.5°
by xDiscoSTUx
1
Downloads
5
Likes
0
Makes
Hello! Here is my new spool holder which is inclined at 22.5 °.
I designed it because my old setup (inclined paper towel holder) did not work
with the new EconoFil PLA rolls purchased (1 kg for 16 $ CAN - filaments.ca) Amazing PLA By The Way!
This Spool Holder is simple but it takes a lot of material but does not require bearings or screws or assembly.
I tested it with a brand new/barely empty spool and the Spool Holder does'nt move
but I'm going to put small pieces of rubber underneat
I designed it because my old setup (inclined paper towel holder) did not work
with the new EconoFil PLA rolls purchased (1 kg for 16 $ CAN - filaments.ca) Amazing PLA By The Way!
This Spool Holder is simple but it takes a lot of material but does not require bearings or screws or assembly.
I tested it with a brand new/barely empty spool and the Spool Holder does'nt move
but I'm going to put small pieces of rubber underneat
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in