Thingiverse
Arc Reactor Mk-1
71
Downloads
75
Likes
1
Makes
All the parts shown were printed in PLA and came out pretty well. The light ring and centre were printed in a transparent filament with 6 bottom and top layers and 50% infill. All the grey parts were printed with 100% infill, with the exception of the base that was 50% infill.
I used 16 blue LEDs that were 9000MCD, as well as a 3V battery pack(2xAA). All the lights were soldered in series using insulated copper wire. I hooked it up to a 6V battery pack(4xAA), it hurt my eyes a bit but it was
I used 16 blue LEDs that were 9000MCD, as well as a 3V battery pack(2xAA). All the lights were soldered in series using insulated copper wire. I hooked it up to a 6V battery pack(4xAA), it hurt my eyes a bit but it was
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in