Thingiverse
Anycubic Kossel - Back Spool Holder
by Master_Aar
8
Downloads
1
Likes
0
Makes
This overly complicated spool holder is made to go with an extruder mounted flat (on top of the power supply in my case). If you have a 12V 30A PSU on your printer, then you can print out the power supply mount which goes with this (https://www.thingiverse.com/thing:2872995).
The spinning model uses 1-3 608zz (normal skateboard) bearings, and an M8 or 5/16" bolt that is 30 to 60 mm long to act as the shaft that the bearings go on. Assembly is pretty easy. Put the bearing/bearings into the bea
The spinning model uses 1-3 608zz (normal skateboard) bearings, and an M8 or 5/16" bolt that is 30 to 60 mm long to act as the shaft that the bearings go on. Assembly is pretty easy. Put the bearing/bearings into the bea
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in