Semi Circular Fan Duct for E3D V6 Direct Drive

I swapped my stock hot end for a E3D V6 using the carriage from Cobratronics. I had been using Lokster's semi circular fan duct on my stock setup and liked it, and wanted to use it on the new setup as well but it didn't fit. I fired up Tinkercad and made some adjustments! lol I used a remix of his original design that has a little smoother surface than the original. It's not perfect by any means, I just quickly cut his duct, move the two halves so the fit the fan and fit around the heater block,