Thingiverse

Mk9 / Mk10 Extruder - Precision Feeder, reliable flex filament prints

by aricblunk

43 Downloads

33 Likes

0 Makes

Download Model

extruder Filament Feeder filament guide Flex flexible filament IIIP maker select V2 Mk10 mk10 extruder mk10 flexible mk10 upgrade MK9 MK9 Extruder Mods for Monoprice monoprice makerselect prusa i3 prusa i3 mk2 Wanhao Duplicator I3 extruder Filament Feeder filament guide Flex flexible filament IIIP maker select V2 Mk10 mk10 extruder mk10 flexible mk10 upgrade MK9 MK9 Extruder Mods for Monoprice monoprice makerselect prusa i3 prusa i3 mk2 Wanhao Duplicator I3

When trying to print TPU on my maker select v2, the filament would inevitably jam after only a few minutes by wrapping itself around the extruder motor gear, even when printing at only 10mm/s.

To enable reliable TPU printing with the Mk9 extruder, I designed a new frame/housing/feeder with less open space around the extruder gear and guide wheel, below the point where filament is being fed/pushed, so the gap is too small for filament to bunch up into, and the only place for it to go is down

Source

Thingiverse

Comments

Makes