Thingiverse
xyz printing kiss new bracket for moving the sensor to the front of the bed
by caj
10
Downloads
6
Likes
0
Makes
kiss all you military know this term "KEEP IT SIMPLE STUPID"
if you do not use your whole bed you will not even notice this till parts start to overheat and not adhere to the middle of the bed
not so bad with ABS and you can go a long time before it is no longer tolerable
but pla will melt small parts while trying to print
while trying to print my princess parking sign this takes the whole bed and the first layers of abs would just bubble up off of the bed from to much heat and turn
if you do not use your whole bed you will not even notice this till parts start to overheat and not adhere to the middle of the bed
not so bad with ABS and you can go a long time before it is no longer tolerable
but pla will melt small parts while trying to print
while trying to print my princess parking sign this takes the whole bed and the first layers of abs would just bubble up off of the bed from to much heat and turn
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in