Thingiverse
Tronxy X5S Steppercooler for XY-Steppermounts
by Speedyturtle
21
Downloads
9
Likes
0
Makes
I finally made a housing for a stepper fan for my TronXY X5S XY-Steppermounts.
https://www.thingiverse.com/thing:2833907
The fan must not be screwed, only put onto the pins.
2x 40mm fan and V-slot screw and nut required.
A bit tricky to install, but works. If you are able to reduce the fan speed, 50% is sufficient.
A little gap between the fan housing and the stepper mount doesn't matter.
Screw the V-slot screw and nut tight onto the housing, push it over the stepper onto the 2020 e
https://www.thingiverse.com/thing:2833907
The fan must not be screwed, only put onto the pins.
2x 40mm fan and V-slot screw and nut required.
A bit tricky to install, but works. If you are able to reduce the fan speed, 50% is sufficient.
A little gap between the fan housing and the stepper mount doesn't matter.
Screw the V-slot screw and nut tight onto the housing, push it over the stepper onto the 2020 e
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in