Thingiverse
TPU/PLA USB Extension Cord Connection Securement Case
by QuickOK
9
Downloads
3
Likes
0
Makes
Needed a USB 3.0 to general USB connection securing device. In my case it's a USB 3.0 extension cable to a Garmin Virb X cable. It was designed to be printed in Ultimaker TPU 95A material, but I assume any Nylon or flexible filament should print fine. There is a bottom and a top (cover?). The cover is designed to be friction held.
Sometimes keeping it simple is easier. Take a rubber band and loop it over itself on one end of a usb cord. Ideally, it should be on the connector and NOT where the
Sometimes keeping it simple is easier. Take a rubber band and loop it over itself on one end of a usb cord. Ideally, it should be on the connector and NOT where the
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in