Thingiverse
Z nut holder for use with 3 wheel system
by 3DPModder
19
Downloads
11
Likes
0
Makes
NOTE: This remix is only needed if you are using NinjaCookie's dual Z upgrade in combination with Cbmx's X-rail 3 wheel system.
Because the 3 wheel system is thicker than the original acrylic, this moves the X rail further towards the rear of the printer, pushing the Z nut holder out of line with the Z rod.
To position it correctly the Z nut holder needs to be shorter, however shortening it enough means the M3 bolt heads will impact the X rail itself, so built up the section under the X r
Because the 3 wheel system is thicker than the original acrylic, this moves the X rail further towards the rear of the printer, pushing the Z nut holder out of line with the Z rod.
To position it correctly the Z nut holder needs to be shorter, however shortening it enough means the M3 bolt heads will impact the X rail itself, so built up the section under the X r
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in