Thingiverse
CR-10 E3D Volcano Titan Aero Part Cooler
by Icarus1uk
36
Downloads
21
Likes
1
Makes
After installing my new E3D Titan Aero extruder on to my volcano hot end I found there weren't many part cooling shrouds for this particular setup compared to the infinite variety of fangs available for the more conventional setups.
The original shroud that this is remixed from was mounted on the wrong side of the extruder to be used on the CR-10 so I modified to be able to be mounted on the other side. You can still access the idler without any issues.
Word of warning. I found fitting the
The original shroud that this is remixed from was mounted on the wrong side of the extruder to be used on the CR-10 so I modified to be able to be mounted on the other side. You can still access the idler without any issues.
Word of warning. I found fitting the
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in