Thingiverse
Easy Breech
by Bennychai
51
Downloads
42
Likes
0
Makes
Hi guys, I designed a easy breech for nerf longshot which requires just a 9/16 brass and a small oring.
Instruction:
1. Print
2. Cut a quarter pipe 9/16 brass (ON PICS ABOVE)
3. Heat up the brass dart guide for 50sec
4. Quickly and carefully sleeve the thin brass into the breech. (ON PICS ABOVE)
5. Test fit and make sure its smooth. (MAY REQUIRE SOME PATIENCE.)
6. Slip on the small oring on the groove of the pusher
7. Test seal.
●●●Important note●●●
While loading this breech to you
Instruction:
1. Print
2. Cut a quarter pipe 9/16 brass (ON PICS ABOVE)
3. Heat up the brass dart guide for 50sec
4. Quickly and carefully sleeve the thin brass into the breech. (ON PICS ABOVE)
5. Test fit and make sure its smooth. (MAY REQUIRE SOME PATIENCE.)
6. Slip on the small oring on the groove of the pusher
7. Test seal.
●●●Important note●●●
While loading this breech to you
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in