Anet A8 X-Axis Extruder Carriage

If you have an older Anet A8 you might need the original diggitydank carriage https://www.thingiverse.com/thing:2031671 because the x end stop is lower. I really liked the design of it but the foot that was meant to hit the x-stop was too low for the newer Anet designs, and on the non-cable-chain model there was nothing to hook/tie/attach the cable chain to for strain relief, and for whatever reason my fiberglass reinforced belts were slipping out of the teeth when I tried to tighten the belt up