Thingiverse
Joycon Jig - 24 AWG Wire- No bending
by GhostlyCrowd
43
Downloads
22
Likes
0
Makes
A remix of https://www.thingiverse.com/thing:2877484
It ain't pretty but it works well.
It fits cat 5e 24 AWG wire, with no need to bend it or adjust it. So no need to fiddle with it. It just works.
Once the wire makes contact with the pins you may see the excess wire slide out of the top of the jig. As shown in the picture. This is normal. the wire stops nested on the pins and the jig will continue to side to lock in place.
I print it at .2mm but if your printer is not very ac
It ain't pretty but it works well.
It fits cat 5e 24 AWG wire, with no need to bend it or adjust it. So no need to fiddle with it. It just works.
Once the wire makes contact with the pins you may see the excess wire slide out of the top of the jig. As shown in the picture. This is normal. the wire stops nested on the pins and the jig will continue to side to lock in place.
I print it at .2mm but if your printer is not very ac
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in