Trigorilla Board (Anycubic) Stepper Driver Cooling
by lexaiden
170
Downloads
94
Likes
4
Makes
Drawn with Solvespace, original 3D files (*.slvs) included. No Support Material needed, each angle is >45°.
The fan could be mounted with M3 screws/nuts. The print should be paused after 4.6mm to place the M3 nuts into the print, the hexagon is then 2,8mm deep. With a layer height of 0,2mm you have to pause the printer after layer 23 (4,6mm / 0,2mm = 23)
The M3 nut to mount the fan duct to the PCB could be placed/hold during the assembly.
The design is made for 40x40mm fans with a heigh
The fan could be mounted with M3 screws/nuts. The print should be paused after 4.6mm to place the M3 nuts into the print, the hexagon is then 2,8mm deep. With a layer height of 0,2mm you have to pause the printer after layer 23 (4,6mm / 0,2mm = 23)
The M3 nut to mount the fan duct to the PCB could be placed/hold during the assembly.
The design is made for 40x40mm fans with a heigh
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in