Thingiverse
Baby or Pet Gate Baseboard Bracket (Remix)
by M3DPS
18
Downloads
16
Likes
0
Makes
This baby or pet gate baseboard bracket is designed to enable the use of certain types of pressure mounted baby or pet gates against a baseboard with quarter round.
Revision 3 has two screw holes and is intended to be printed using PLA or ABS. Installation requires two appropriately sized screws per bracket because the bracket can slide too easily if mounted by compression alone.
Revision 2 does not have any screw holes and is intended to be printed using Ninjaflex filament so that it can
Revision 3 has two screw holes and is intended to be printed using PLA or ABS. Installation requires two appropriately sized screws per bracket because the bracket can slide too easily if mounted by compression alone.
Revision 2 does not have any screw holes and is intended to be printed using Ninjaflex filament so that it can
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in