Thingiverse
Epoxy paddle small
by johnjonhson
8
Downloads
6
Likes
0
Makes
Small epoxy mix paddle (20mm diameter) based on Paint Stir Drill Bit by birdshotbrad.
Openings in paddle are to make less drag.
Center shaft hole fits a 1/16" diameter rod for drill use. The metal rod will eliminate the vibration that would occur if the shaft were 3D printed. Mount upside down to scrape sides/bottom of epoxy container.
Openings in paddle are to make less drag.
Center shaft hole fits a 1/16" diameter rod for drill use. The metal rod will eliminate the vibration that would occur if the shaft were 3D printed. Mount upside down to scrape sides/bottom of epoxy container.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in