Thingiverse
Wanhao i3 fan shroud and pi zero enclosure
by jrucker2004
10
Downloads
2
Likes
0
Makes
UPDATE: I cannot recommend using this setup.
I've been having a lot of problems with the zero4u usb hub, which disconnects randomly and stops a print part way through. This is a known problem, but I thought it was resolved.
As a result, DO NOT USE THE HUB! I'm going to come up with a better solution, but I haven't figured it out yet.
This fan shroud attaches to the back of the power supply on the wanhao i3 or monoprice maker select v2.
It allows you to upgrade to a 100mm exhaust fan,
I've been having a lot of problems with the zero4u usb hub, which disconnects randomly and stops a print part way through. This is a known problem, but I thought it was resolved.
As a result, DO NOT USE THE HUB! I'm going to come up with a better solution, but I haven't figured it out yet.
This fan shroud attaches to the back of the power supply on the wanhao i3 or monoprice maker select v2.
It allows you to upgrade to a 100mm exhaust fan,
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in