Thingiverse
1KG Spool Holder for CR-10S/With Desicant Pocket
by phigment
8
Downloads
5
Likes
0
Makes
All Parts printed at .2 resolution, using PLA+.
Temp 218c
Bed 60c
Brim 5 mm
Print Speed of 55 mm per second.
Top came out a a good pressure fit to the main body, inner ring requires a bit of sanding. Also on first iteration I forgot to put in a hole in the inner ring to match up with the out hole for the filament.
The filament out (outside of the case is designed for a PC4-M6 Fitting, to which you can either add a bowden tube for direct feed systems, or leave it as it is.
8/22
Temp 218c
Bed 60c
Brim 5 mm
Print Speed of 55 mm per second.
Top came out a a good pressure fit to the main body, inner ring requires a bit of sanding. Also on first iteration I forgot to put in a hole in the inner ring to match up with the out hole for the filament.
The filament out (outside of the case is designed for a PC4-M6 Fitting, to which you can either add a bowden tube for direct feed systems, or leave it as it is.
8/22
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in