Thingiverse
Folger Tech Effector Tower Mount with E3D Lite6 and 3010 Fan
by GeoDave
11
Downloads
6
Likes
0
Makes
**5/7/2018**
I made a few adjustments to the design.
1. The 30mm Fan is now fits between 2 parrallel rods.
2. Chamfered the inside edge to give a little more clearance on hotend
3. Added Eject holes for the nuttraps in base in case they are stuck when trying to take them out.
4. Took out theNuttrap at top and use M3x22mm screw to a locknut on the back.
5. Changed my default Nuttrap 6.4mm
6. Added wiretie cylinders to each side of front of hotend. If you have the cube hotend portion pointi
I made a few adjustments to the design.
1. The 30mm Fan is now fits between 2 parrallel rods.
2. Chamfered the inside edge to give a little more clearance on hotend
3. Added Eject holes for the nuttraps in base in case they are stuck when trying to take them out.
4. Took out theNuttrap at top and use M3x22mm screw to a locknut on the back.
5. Changed my default Nuttrap 6.4mm
6. Added wiretie cylinders to each side of front of hotend. If you have the cube hotend portion pointi
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in