Thingiverse
Creality CR 10 500mm 300mm Frame Braces, spool holder and control box support
355
Downloads
219
Likes
0
Makes
These are my upgrades for the Creality CR-10 S5 500mm printer.
The frame braces and spool holder uses M8 threaded rods and M8 nuts.
The spool holder uses two 608 ball bearings
The rods must be at least 72 cm long for the two braces and 15 cm for the spool holder.
So if you buy two 1m rods you should have more than enough.
The parts are mounted to the frame with M4 bolts and matching T slot nuts.
You will need 18 T slot nuts in all.
All parts should print easily with no or minim
The frame braces and spool holder uses M8 threaded rods and M8 nuts.
The spool holder uses two 608 ball bearings
The rods must be at least 72 cm long for the two braces and 15 cm for the spool holder.
So if you buy two 1m rods you should have more than enough.
The parts are mounted to the frame with M4 bolts and matching T slot nuts.
You will need 18 T slot nuts in all.
All parts should print easily with no or minim
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in