Thingiverse
Prusa i3 MK2S Display Cover
by Licantrop
7
Downloads
3
Likes
0
Makes
This is a complete rework from scratch of the Display Covert for Prusa I3 MK2S.
At least i could try it out only with my original Display board for MK2S.
It might fit for other versions too but i can not guaranty!
Attention:
- Especially the brackets are for V-Slot 4020 and Bear Upgrade.
- As i use different feet (see my other things) it will not fit with original Bear Upgrade Feet. You will need at least 16 mm (better a bit more) of clearance from lower side of bottom frame downwards. O
At least i could try it out only with my original Display board for MK2S.
It might fit for other versions too but i can not guaranty!
Attention:
- Especially the brackets are for V-Slot 4020 and Bear Upgrade.
- As i use different feet (see my other things) it will not fit with original Bear Upgrade Feet. You will need at least 16 mm (better a bit more) of clearance from lower side of bottom frame downwards. O
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in